RESUMO
This study investigated the effect of water sorption and bleaching on light transmission properties (Straight-light transmission (G0), Light diffusion (DF) and Amount of transmitted light (AV)) and translucency parameters (TP) of nano-filled flowable composites. A total of 35 composite disks (0.5 mm thickness) were prepared using A2 shade of 5 nanofiller composites (n = 7/each); Beautifil Flow Plus X F03 (SHOFU INC), Clearfil Majesty ES Flow (Kuraray Noritake Dental), Estelite Universal Flow (EUF, Tokuyama Dental), Estelite Flow Quick (Tokuyama Dental) and Filtek Supreme Ultra Flowable Restorative (FSU, 3M ESPE). Then, they were cured by LEDs (VALO, Ultradent) on standard mood (1000 mW/cm2) for 20 s. Samples were tested for straight-line transmission (G0), diffusion (DF), the amount of transmitted light (AV) and (TP) immediately after 24 h (dry storage), after 1-week water storage and after each of the three cycles of in-office bleaching (HiLite, SHOFU INC). Result: G0, DF, AV and TP were significantly affected by different materials (p < 0.001). The AV of FSU increased significantly after the 1-week water storage, then after the second bleaching cycle (p < 0.001). The TP for EUF slightly decreased (p = 0.019) after 1-week water storage, then increased throughout bleaching. Conclusion: Ageing/bleaching conditions do not affect G0, DF, AV and TP. The compositional variation between nano-filler composites resulted in a significant difference between materials.
RESUMO
The effect of 1-week water storage and subsequent 10,000 thermal cycles on light transmission properties (straight-line transmission (G0), diffusion (DF), the amount of transmitted light (AV)), translucency parameter (TP) and refractive index (RI) of four nanofilled flowable composites was examined. The composites included Filtek Supreme Ultra Flowable Restorative (FSU), Estelite Flow Quick (EFQ), Estelite Universal Flow, (EUF), and Clearfil Majesty ES Flow (ESF), all of A3 shade. For composites with lower filler load (FSU, EFQ), water storage increased G0, AV and TP, but subsequent thermocycling decreased them. An opposite tendency was found for DF. Materials with higher filler load (EUF, ESF) were not significantly affected by aging conditions. RI of EFQ and EUF containing bisphenol A polyethoxy methacrylate (Bis-MPEPP) increased significantly after thermocycling. Additionally, morphological changes were observed using scanning electron microscopy which revealed cracks within nanocluster fillers and dislocation of particles in FSU and EFQ after thermocycling.
